Not sure where to post this, but here goes:
I have a new PC. I run two monitors. Monitor 1 is a Samsung SyncMaster 931B. Monitor 2 is a cheap used uncalibrated monitor, a Philips Btilliance 150P3. Control Panel correctly identifies monitor 1 as a Syncmaster 931B, and number 2 as a Philips. When I try to calibrate #1, Spyder gives me a choice of "Generic PnP 1", or Syncmaster. I have to choose Generic PnP, to calibrtate it. If I select Syncmaster, spyder thinks that is the cheap Philips, and jumps to that screen. I have calibrated monitor 1 using "Generic PnP-1", but feel I may be losing some performance not using the mfg's driver. Can anyone help? I did download the latest digital Syncmaster driver and installed it. Spyder tech people said swap plugs on back of PC. No help.
Thanks
Dave
Beach Haven, NJ USA
I have a new PC. I run two monitors. Monitor 1 is a Samsung SyncMaster 931B. Monitor 2 is a cheap used uncalibrated monitor, a Philips Btilliance 150P3. Control Panel correctly identifies monitor 1 as a Syncmaster 931B, and number 2 as a Philips. When I try to calibrate #1, Spyder gives me a choice of "Generic PnP 1", or Syncmaster. I have to choose Generic PnP, to calibrtate it. If I select Syncmaster, spyder thinks that is the cheap Philips, and jumps to that screen. I have calibrated monitor 1 using "Generic PnP-1", but feel I may be losing some performance not using the mfg's driver. Can anyone help? I did download the latest digital Syncmaster driver and installed it. Spyder tech people said swap plugs on back of PC. No help.
Thanks
Dave
Beach Haven, NJ USA