S
sirvine
Guest
I'm not sure what happened, but the locking mechanism on the baseplate of my M8 is now "out of phase" with the camera side of the lock. Before, I would turn the lock until it stops, and then tuck the lock's handle into the recess. Now, a full turn of the lock leaves the handle in almost 180 degree position from the recess where it belongs. As a result, I can only turn the lock about one-quarter turn before it lines up with the recess. This works, but the baseplate is wobbly since the lock is not fully tightened up.
Is there any way to adjust this? I see a screw on the inside of the lock, but I haven't tried to disassemble it yet.
Is there any way to adjust this? I see a screw on the inside of the lock, but I haven't tried to disassemble it yet.