L
Lorri1250
Guest
Hello there
With my new Leaf Aptus-II 5 on my Hasselblad 503 CW I worked with a 40mm CF IF for Architecture inside an new built office. There was heavy mixed light in there (outside and inside).
Now I got lens cast on my back. Normally I know this only from shift/tilt, but i didn't expect it on my Hasselblad. Now I have follow trouble:
1. I didn't make any white diffuse picture to kill lens cast per LCC.
2. Normally Capture One Pro 6 goes quite well, if it knows the lens.
The lens I selected manuell inside the new software of Leaf (40mm).
3. In Capture One Pro it says the 40mm, I can select "generic", but I can't select the LCC. It's gray. With the same combination, but 80mm it knows it and works quite well, but not the 40mm.
In case, I would make some new white diffusion pics with the same aperture, iso etc. could it work? But how can I select the white diffusion image in Capture One Pro, if the LCC mode is non working?
Does anybody know, how I can remove the lens cast by any other process? I have Capture One Pro, Leaf Software (newest) and of course Photoshop CS 4/5.
Hope my english was fine enough to explain.
Thanks to all
Lorri
With my new Leaf Aptus-II 5 on my Hasselblad 503 CW I worked with a 40mm CF IF for Architecture inside an new built office. There was heavy mixed light in there (outside and inside).
Now I got lens cast on my back. Normally I know this only from shift/tilt, but i didn't expect it on my Hasselblad. Now I have follow trouble:
1. I didn't make any white diffuse picture to kill lens cast per LCC.
2. Normally Capture One Pro 6 goes quite well, if it knows the lens.
The lens I selected manuell inside the new software of Leaf (40mm).
3. In Capture One Pro it says the 40mm, I can select "generic", but I can't select the LCC. It's gray. With the same combination, but 80mm it knows it and works quite well, but not the 40mm.
In case, I would make some new white diffusion pics with the same aperture, iso etc. could it work? But how can I select the white diffusion image in Capture One Pro, if the LCC mode is non working?
Does anybody know, how I can remove the lens cast by any other process? I have Capture One Pro, Leaf Software (newest) and of course Photoshop CS 4/5.
Hope my english was fine enough to explain.
Thanks to all
Lorri