Don Libby
Well-known member
I (think) remembering seeing a post where someone removed the bumpers on a WDS/WRS lens panel replacing them with a rod of some type.
I had to remove the bumpers on my 72mm as they got in the way of the new Cambo compendium hood. Without them it works as it should however I'm also thinking I'd like to try the single rods screwed in at least on the top corner.
Hope this make sense to at least the person who has done this. I removed the bumpers yesterday with a great deal of effort. # of the 4 screws were so over torque that I ended up cutting the bumpers off not something I'd do to a new lens however this one is close to 4-years old.
And on another note - can one (meaning me) buy the lens plate itself from Cambo? Just thinking resale if I ever decide to sell it sometime in the next 20-years....
Don
I had to remove the bumpers on my 72mm as they got in the way of the new Cambo compendium hood. Without them it works as it should however I'm also thinking I'd like to try the single rods screwed in at least on the top corner.
Hope this make sense to at least the person who has done this. I removed the bumpers yesterday with a great deal of effort. # of the 4 screws were so over torque that I ended up cutting the bumpers off not something I'd do to a new lens however this one is close to 4-years old.
And on another note - can one (meaning me) buy the lens plate itself from Cambo? Just thinking resale if I ever decide to sell it sometime in the next 20-years....
Don