Perhaps this has been covered, but what do folks do for white balance? My workflow is pretty standard for back-shifted pano's with a tech cam (one LCC per exposure). However when I open RAW files (IQ 160) in C1, in the color tab, "Phase One P65+ Flash V2" is the default ICC profile and the default curve is "film standard".
In my workflow I first change, in the ICC profile to "Phase One P65+ Outdoor Daylight" and the curve to "Linear Response". I then use the eye dropper in the White Balance tab on the middle of each LCC for grey. Next I apply these new settings for these Base Characteristics and White Balance to associated image frame (LCC was previously applied to the frame).
Is this how others set white balance or is there a better way (other than using a Greteg card)?
Thanks!
Bob
In my workflow I first change, in the ICC profile to "Phase One P65+ Outdoor Daylight" and the curve to "Linear Response". I then use the eye dropper in the White Balance tab on the middle of each LCC for grey. Next I apply these new settings for these Base Characteristics and White Balance to associated image frame (LCC was previously applied to the frame).
Is this how others set white balance or is there a better way (other than using a Greteg card)?
Thanks!
Bob