PeterA
Well-known member
There are a few guys who use the RZPro11D and I am hoping that someone can help me here..
I have a Mamiya tilt shift adaptor and I have a problem.
The RZ works perfectly with my Sinar back and RZ adaptor. I use the connecting cord supplied by Sinar and connect the back to the lens flash sync and Bob's your uncle.
When I attach the tilt shift bellows accessory however, I note the following:
1. It doesnt work by attaching the same cord to the same lens sync socket and digi back.
2. So I checked on Mamiya site - no instructions..
3. I noticed that on Mamiya site - there is a little connecting cable apparently connecting the tilt shift bellows to the camera body. I dont have one of these - do I need one? I also cant see where I would connect this little gadget on the bellows and then the body?
4. I have a Mamiya cable thing with two screw in plungers connected to a single trigger. This connects to the sync socket on lens but not to my Sinar back.
So I dont have any instruction for using this tilt shift bellows thing - and I dont know what the little connector that is pictured next to the device on the mamya site site is and I dont know what the double trigger Mmaiya thing that I have is for.
I would appreciate any information help here in getting this tilt shift up and running.
thanks
Pete
I have a Mamiya tilt shift adaptor and I have a problem.
The RZ works perfectly with my Sinar back and RZ adaptor. I use the connecting cord supplied by Sinar and connect the back to the lens flash sync and Bob's your uncle.
When I attach the tilt shift bellows accessory however, I note the following:
1. It doesnt work by attaching the same cord to the same lens sync socket and digi back.
2. So I checked on Mamiya site - no instructions..
3. I noticed that on Mamiya site - there is a little connecting cable apparently connecting the tilt shift bellows to the camera body. I dont have one of these - do I need one? I also cant see where I would connect this little gadget on the bellows and then the body?
4. I have a Mamiya cable thing with two screw in plungers connected to a single trigger. This connects to the sync socket on lens but not to my Sinar back.
So I dont have any instruction for using this tilt shift bellows thing - and I dont know what the little connector that is pictured next to the device on the mamya site site is and I dont know what the double trigger Mmaiya thing that I have is for.
I would appreciate any information help here in getting this tilt shift up and running.
thanks
Pete