i've been trying to tune up this arrangement. my prints are mostly sq format, 17 x 17, so i an trying 17" wide roll paper instead of cut sheets.
so far:
paper curl on the leading edge was giving me a smear aboout 3/4' down from the top, i adjusted the paper thickness on the printer to #1 and that has helped.
the curl also makes the outputting edge of the paper hang up occasionally on the output tray. lifting the paper as it is coming out. this has already scratched a print.
the cut function on the printer is dicey...at first it cut all the way through, but now it is leaving the first 1" or so incompletely cut. also the position of the cut line is tricky to set so you don't end up with too much waste (i'd be happy with 3/4" top and bottom.) if you just hit the cut button after the paper is fed out, it wastes about 5" of paper, so you have to manually feed the paper back in tot he cut line and then cut it off, that makes you guess a bit.
had to clean the nozzles twice and do an alignment to get a good print, but now they look great
any comments?
i have considered buying the roll paper and then cutting it to 17 x 17 squares and sheet feeding it
thkx