2jbourret
New member
Not long after beginning to print files from an IQ180, my standard print pipeline has quit cooperating. I print from LR4.0 (no RIP) via USB to an Epson9900 with current firmware and driver. My older files continue to print fine (P45+ and smaller formats), but the IQ180 files seem to get lost before making it to the printer: The LR4 progress bar shows the print file 'rendering' as it should, but for a period of 4-6 min., which is long compared to smaller files. Normally, I would then see the print file show up on the Epson print monitor, and the status would read 'printing' as the file printed. What happens instead with the IQ files is either nothing at all, or the print monitor will display a status of 'on hold', and then the file will disappear from the print monitor. In either case, no print is made.
I'd welcome any ideas on solving this. Thanks!
My hardware:
MacPro 2x2.66 Dual-Core
12 GB 667mhz DIMMS
2TB Startup disk
OS 10.6.8
Printer connected by USB, w/powered hub at middle to boost range to ~22ft.
I'd welcome any ideas on solving this. Thanks!
My hardware:
MacPro 2x2.66 Dual-Core
12 GB 667mhz DIMMS
2TB Startup disk
OS 10.6.8
Printer connected by USB, w/powered hub at middle to boost range to ~22ft.