Transposure
New member
Hey All,
I am resurrecting this thread because I have a specific question relating to the design of a new case upon which I am working.
I found a great condition Phase One Aluminum case (Amabilia) and I am outfitting it with www.mycasebuilder.com custom foam. I love this process and product.
So, I created a new design to suit my needs. 3D design below..
The foam is meant for this case...
If you haven't guessed, I am going for the James Bond look. LOL
Anyway, one item I am planning for, and do not yet own, is the Waist Level Viewfinder for the XF. That is the the squarish cutout near the center. I obtained the dimensions of the WLV from the Phase One site. It says the WLV is 2.6378"x.6693"x2.2441" (converted from metric).
However, after seeing the following photo, I want to take into account the height of the WLV with the rubber cap installed. You can see it below. It appears the Phase One spec'd width and length are unaffected, but the height is a question. Can someone measure the height of the WLV with the rubber protection cap installed? In the photo below, I am looking for height from the table top to the top of the WLV as it is shown.
Thanks in advance!!
Ken
I am resurrecting this thread because I have a specific question relating to the design of a new case upon which I am working.
I found a great condition Phase One Aluminum case (Amabilia) and I am outfitting it with www.mycasebuilder.com custom foam. I love this process and product.
So, I created a new design to suit my needs. 3D design below..
The foam is meant for this case...
If you haven't guessed, I am going for the James Bond look. LOL
Anyway, one item I am planning for, and do not yet own, is the Waist Level Viewfinder for the XF. That is the the squarish cutout near the center. I obtained the dimensions of the WLV from the Phase One site. It says the WLV is 2.6378"x.6693"x2.2441" (converted from metric).
However, after seeing the following photo, I want to take into account the height of the WLV with the rubber cap installed. You can see it below. It appears the Phase One spec'd width and length are unaffected, but the height is a question. Can someone measure the height of the WLV with the rubber protection cap installed? In the photo below, I am looking for height from the table top to the top of the WLV as it is shown.
Thanks in advance!!
Ken