dnercesian
New member
As my new kit will be arriving shortly, I am wondering how you guys transport your Cambo/Alpa/Arca tech cams from job to job. I have been warned to be fairly precious with the 32mm HR due to the size and weight of the elements, so I figure the same rule should apply during transport.
I have been looking (maybe not diligently enough) for a pre-cut hard case, but so far have not been successful. I was starting to consider a pluck & pull Pelican case, but my experience with those is that they can get messy after a while. I was looking at maybe the Pelican cases with the dividers also, and I don't think that is a bad solution for the XF and those lenses, but I am thinking that a little more padding may be useful for the tech stuff.
Thanks for any and all opinions and ideas on this.
I have been looking (maybe not diligently enough) for a pre-cut hard case, but so far have not been successful. I was starting to consider a pluck & pull Pelican case, but my experience with those is that they can get messy after a while. I was looking at maybe the Pelican cases with the dividers also, and I don't think that is a bad solution for the XF and those lenses, but I am thinking that a little more padding may be useful for the tech stuff.
Thanks for any and all opinions and ideas on this.