The GetDPI Photography Forum

Great to see you here. Join our insightful photographic forum today and start tapping into a huge wealth of photographic knowledge. Completing our simple registration process will allow you to gain access to exclusive content, add your own topics and posts, share your work and connect with other members through your own private inbox! And don’t forget to say hi!

Hasselblad CFV "Error System (9022)" message

elrafo

Member
Hello Guys,


been super excited to use my CFV16 with my recently bought SWC (1980 model) and now I get this error message very often "Error System (9022)" :( :(

was about to leave on a trip and I think instead I will have to leave the camera to a repair shop !!

any idea on what kind of issue this could be ?

I re updated the firmware to R267, no changes.

the error messages is usually after I leave the back off for a couple of minutes, I can reset the back when removing the battery but the System error message keeps showing...



https://www.dropbox.com/preview/00_PHOTO/SWC/IMG_3603.JPG

 

HBIEVP

New member
Hello Guys,


been super excited to use my CFV16 with my recently bought SWC (1980 model) and now I get this error message very often "Error System (9022)" :( :(

was about to leave on a trip and I think instead I will have to leave the camera to a repair shop !!

any idea on what kind of issue this could be ?

I re updated the firmware to R267, no changes.

the error messages is usually after I leave the back off for a couple of minutes, I can reset the back when removing the battery but the System error message keeps showing...



https://www.dropbox.com/preview/00_PHOTO/SWC/IMG_3603.JPG

Elrafo,

9022 is a signal processing error that will require service, please contact [email protected] regarding.

Sincerely,

Eric Peterson
Field Sales Specialist
Hasselblad
 

PSon

Active member
I also had similar problem and my digital was sent in for service and now it is working properly. Since my digital back required a whole new circuit board, the solder battery was also replaced and now the date is correct. Good luck.
 

elrafo

Member
sounds like the same issue I have, I can't set my Date properly, it always reset to 2000.

I find a bit ridiculous that it requires a full replacement of the board when we could just replace the battery, like in every single other boards.

I have a Dx7 Synthesiter, 25 years old, I replaced the battery and works like a charm.

I also had similar problem and my digital was sent in for service and now it is working properly. Since my digital back required a whole new circuit board, the solder battery was also replaced and now the date is correct. Good luck.
 

PSon

Active member
Unfortunately the battery issue is not isolated to only Hasselblad digital back.
 
Top