carstenw
Active member
Having just received and started using an almost-new eMotion 54LV, and having struggled with workflow for a few days until settling into a nice rhythm, I thought I would start this thread for the Sinar owners on this forum to write about their problems and solutions.
My current workflow is very simple, drag the images to my incoming folder (converting to DNG), load them up, and go through them, setting Brightness, Contrast, WB, and Saturation. The rest of the settings I find good on default so far. Then I load them into Lightroom where I can process a little further, without having lost any sharpness or gotten any noise from its lousy algorithms in those two areas.
Some outstanding problems: Lightness levels: I am on the road and I find it hard to judge the lightness of the results. Any tips are very welcome. Noise: I rarely see noise, but sometimes I expose a little low. I would enjoy tips on how to control noise with eXposure.
I also would like to change the default settings. The Saturation is set to -10 by default, for example. I would like to set this to 0 or even 10, and save that. Is there a way?
How can one process multiple images at the same time, setting WB etc?
Is there some way to speed up export? This part of the process takes a very long time.
I look forward to any tips!
My current workflow is very simple, drag the images to my incoming folder (converting to DNG), load them up, and go through them, setting Brightness, Contrast, WB, and Saturation. The rest of the settings I find good on default so far. Then I load them into Lightroom where I can process a little further, without having lost any sharpness or gotten any noise from its lousy algorithms in those two areas.
Some outstanding problems: Lightness levels: I am on the road and I find it hard to judge the lightness of the results. Any tips are very welcome. Noise: I rarely see noise, but sometimes I expose a little low. I would enjoy tips on how to control noise with eXposure.
I also would like to change the default settings. The Saturation is set to -10 by default, for example. I would like to set this to 0 or even 10, and save that. Is there a way?
How can one process multiple images at the same time, setting WB etc?
Is there some way to speed up export? This part of the process takes a very long time.
I look forward to any tips!