Speedgraphic
Member
I'm trying to make small proofs prior to making finals from my Epson. I figured I could just make a custom print size of 4x24". Then I make a custom picture package containing the small proofs. However the output was bizarre. I placed 3 4x5s on the 4x24 spread, but only ONE was printed, and not even fully. It printed about an inch. I figured this may have been a fluke so I double checked everything and printed again, same result.
The only was I was able to produce all three proofs, was to set a print size of 10x12 (which was a preset size), and print that. Of course that's ridiculous because you're ALWAYS printing X by 24" with the P6000.
The only was I was able to produce all three proofs, was to set a print size of 10x12 (which was a preset size), and print that. Of course that's ridiculous because you're ALWAYS printing X by 24" with the P6000.