Not sure if this is the correct forum, but I'll start here.
I just bought an iMac 2017 and (used to) have a 2 monitor system on my 8YO Mac. The Eizo CX271 worked fine with the DVI port on the Mac.
Now I don't have a DVI port in the iMac: only 2 Thunderbolt3 ports and 4 USB 3.2 (I think) ports. I've bought just about every Apple Thunderbolt accessory:
. Thunderbolt to HDMI (works with the Eizo)
. Thunderbolt to DVI (not sure it's truly Thunderbolt 3 as there is a monitor symbol on the Thunderbolt end and a DVI male connector on the other end)
. Thunderbolt3 to USB C connector. Used to connect a USB C male and mini-port from the connector to the Eizo.
I've tried all of these with the appropriate wires to interface from the iMac to the corresponding port on the CX271. Only the HDMI works, but I cannot get the high (recommended on the monitor screen) resolution with the HDMI, even when I try all Hz options.
Any help getting this to work would be greatly appreciated! Neither the Eizo support sight has an answer, nor does a call to Brad at Capture Integration (to be honest, I haven't called Brad back and he didn't have a whole lot of time to research further).
Thanks,
Bob
I just bought an iMac 2017 and (used to) have a 2 monitor system on my 8YO Mac. The Eizo CX271 worked fine with the DVI port on the Mac.
Now I don't have a DVI port in the iMac: only 2 Thunderbolt3 ports and 4 USB 3.2 (I think) ports. I've bought just about every Apple Thunderbolt accessory:
. Thunderbolt to HDMI (works with the Eizo)
. Thunderbolt to DVI (not sure it's truly Thunderbolt 3 as there is a monitor symbol on the Thunderbolt end and a DVI male connector on the other end)
. Thunderbolt3 to USB C connector. Used to connect a USB C male and mini-port from the connector to the Eizo.
I've tried all of these with the appropriate wires to interface from the iMac to the corresponding port on the CX271. Only the HDMI works, but I cannot get the high (recommended on the monitor screen) resolution with the HDMI, even when I try all Hz options.
Any help getting this to work would be greatly appreciated! Neither the Eizo support sight has an answer, nor does a call to Brad at Capture Integration (to be honest, I haven't called Brad back and he didn't have a whole lot of time to research further).
Thanks,
Bob