danlindberg
Well-known member
I have been using this printer for a good many years and it has given me consistent results. Don't laugh, but I have not used any profiles, auto colour management and output in sRGB, just about everything 'standard'.
And it has given me very accurate colours and I have not dared to try and tweak anything. Classic thinking - if not broken, don't fix it.
Now, I had to exchange both printerheads and at the same time I updated the firmware for the first time. From original 1.20 to current 1.38.
The printer started up without problems and I have printed several canvases but here is the problem. With the old settings it prints both darker and excessive saturation. It almost looks like it prints with too much ink, it is not quite dry when it comes out.
Any suggestions? Thanks.
And it has given me very accurate colours and I have not dared to try and tweak anything. Classic thinking - if not broken, don't fix it.
Now, I had to exchange both printerheads and at the same time I updated the firmware for the first time. From original 1.20 to current 1.38.
The printer started up without problems and I have printed several canvases but here is the problem. With the old settings it prints both darker and excessive saturation. It almost looks like it prints with too much ink, it is not quite dry when it comes out.
Any suggestions? Thanks.