Hi all -
I just can't seem to get this right.
I"m using the Phase One kit, and following the instructions closely, but I keep ending up with streaks across the width of the sensor following application and evaporation of the second fluid.
What I do is this -
1. Wrap two of the cloths around the black scraper, then wet the edge with solution A.
2. One firm, relatively quick swipe across the sensor, holding the scraper at an angle of around 45 degrees to the sensor, and just firm enough that it bends ever so slightly.
3. As per (1), but with fresh cloths and solution B.
4. As per (2).
I've watched this video - Cleaning kit | Phase One P+ digital camera back - YouTube but am a little confused because it doesn't appear to follow the instructions on the box.
Any help gratefully received!
Kind regards,
Gerald.
I just can't seem to get this right.
I"m using the Phase One kit, and following the instructions closely, but I keep ending up with streaks across the width of the sensor following application and evaporation of the second fluid.
What I do is this -
1. Wrap two of the cloths around the black scraper, then wet the edge with solution A.
2. One firm, relatively quick swipe across the sensor, holding the scraper at an angle of around 45 degrees to the sensor, and just firm enough that it bends ever so slightly.
3. As per (1), but with fresh cloths and solution B.
4. As per (2).
I've watched this video - Cleaning kit | Phase One P+ digital camera back - YouTube but am a little confused because it doesn't appear to follow the instructions on the box.
Any help gratefully received!
Kind regards,
Gerald.